![]() |
|
![]() |
#1 |
Guest
Posts: n/a
|
![]()
Hi,
I just recently bought a CO2 diffuser. I just saw that the bubble is coming out from 5 tiny holes on one side of the large white surface. Is there any way to make the bubble coming out from the round surface evenly? Thanks! |
![]() |
![]() |
#2 |
Guest
Posts: n/a
|
![]()
I think it is quite common for it not to be so evenly distributed. If the pressure is not so strong then it will just come out from a few areas.
I only get a wider distribution when I have higher bps so the pressure will force it to come out from more pores. |
![]() |
![]() |
#3 |
Guest
Posts: n/a
|
![]()
I will try to increase the CO2 to utilize the diffuser area then decrease the CO2 again.
|
![]() |
![]() |
Tags |
co2, diffuser |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|