|
17-02-2015, 12:57 PM | #31 |
Arofanatic
Join Date: Jan 2015
Posts: 56
|
After one day
Pardon if picture still big. Trying to adjust here. |
17-02-2015, 12:58 PM | #32 |
Arofanatic
Join Date: Jan 2015
Posts: 56
|
|
17-02-2015, 01:10 PM | #33 |
Dragon
Join Date: Jul 2001
Posts: 1,141
|
Your wavemaker should be on the left side ..... place it lower and nozzle pointing slightly 45 degrees down on the tank base blowing towards the underflow area . Do not blow at your airstone ....
|
17-02-2015, 01:42 PM | #34 |
Arofanatic
Join Date: Jan 2015
Posts: 56
|
I'm confused. So do I place it on the left or right? My tank is not rectangular in size. There's 2 triangular box at the both end of the sides.
|
17-02-2015, 08:10 PM | #35 |
Dragon
Join Date: May 2007
Posts: 768
|
No need confuse de, it doesn't matter rite nor left side, cos when big tank or the VM may be weak to cause a reflect, position it direct as some bro mentioned....Tweak the angle and location to observe till rite mah.
Imo, u do not need to turn on the VM 24/7 de. Btw, you shud be gaining underflow, soon when the correct position established most poo will be gone. Last edited by kepala sakit; 17-02-2015 at 08:19 PM. |
18-02-2015, 01:23 PM | #36 | |
Arofanatic
Join Date: Jan 2015
Posts: 56
|
Quote:
|
|
18-02-2015, 01:25 PM | #37 | |
Arofanatic
Join Date: Jan 2015
Posts: 56
|
Quote:
|
|
18-02-2015, 01:38 PM | #38 |
Dragon
Join Date: Jul 2001
Posts: 1,141
|
Place ur wave maker on the left side nearer to tank front 6 to 8 inches high . do not let the air stone obstruct the flow of the wm .
By right ur output at the corner left should be able to blow the shit to the underflow if your return pump is strong enough . if after tweaking around still not able to blow the shit towards the underflow ..... Should be ur eos under and overflow design problem Liao . |
18-02-2015, 09:01 PM | #39 | |
Arofanatic
Join Date: Jan 2015
Posts: 56
|
Quote:
|
|
18-02-2015, 10:06 PM | #40 | |
Arofanatic
Join Date: Jan 2015
Posts: 56
|
Quote:
Bro like this? |
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|