Arofanatics Fish Talk Forums - View Single Post - How to building your own Thermoelectric Chiller

19-09-2009, 01:59 PM

hi folks

check the temp again it was 22.5*C propably due to rainny day.
i notice some drops of water forming at the side to the peliter.
it this bad for peltier?

how can i prevent the drops of water forming?
can i seal the peliter sides with silicon glue?

will sealing up with silicon heatup the peliter and cause failure?

thanks

19-09-2009, 01:59 PM	#86
ksc133 Guest Posts: n/a	hi folks check the temp again it was 22.5*C propably due to rainny day. i notice some drops of water forming at the side to the peliter. it this bad for peltier? how can i prevent the drops of water forming? can i seal the peliter sides with silicon glue? will sealing up with silicon heatup the peliter and cause failure? thanks