Quote:
Originally Posted by Occellatus
Ok. I will bring your dimensions to go cut tomorrow. Should be correct based on what I've counter measured earlier. I will tell them to split the entire thing into half so that I can place them in.
|
Put in must got skill also hoh .
First lower the pc without EOS halfway only and use a long pvc pipe or those mr aqua ohf long piping . ( Inverted broom also can lah
)
Hold half the acrylic and slowly lay down once u get it to sit in between ur bracing , then slowly use the hard piping to push to the end first .
The again do the same for the eos part , leave some gap for the EOS part so next time can remove easily .
(* My dimension already got gap allowance so dun go and minus further )