Quote:
Originally Posted by scottelfy
bro mind helping me with 7ftx28" base? probably need 3 pieces otherwise it might be too big?
|
Again i say before u want to use my measure , MAKE SURE UR TANK BRACING IS 3 " ALL ROUND !!!
Need how many pc up to u .... for your info my tank is 6.5ft L X 2.5ft W and 2 pc can go in easily !
Let me REPEAT how to measure again ....
First get ur tank outer dimension lenght and width
Ur case Length is 7ft = 84 inch ( 84 " minus off both side 6 " bracing = 78 " ) READ PROPERLY HOH ! Then 78" see how many pc u want to divide .
E.G now 78" convert to mm first = 1982mm ( then u split to eg half = 991 mm per pc , so now u got 2 pc of 991mm , get it ? )
Then u will need to minus off both pc off about 5mm each side for some gap .
Can catch up ? So now u got 2 pc Lenght 986 mm .
For your Width part same
Width is 28 "
28" minus both side total 6" bracing = 22"
22" convert to mm = ( 559 mm ) width gap allowance just minus around 3mm
So ur width is 556mm .
For the EOS part .... u cannot follow my drawing 385mm already cause ur width is 2" smaller . Just climb up ur tank and measure how i draw out in post
85 !!!
Measure from ur top bracing outer edge to ur EOS slant part EOS .
PS ( To all those pm , i really dun have time to come up with all the different measurement for u guys ! ) Just go through how i measure and the picture posted here in this thread . Its not that difficult ,
JUST SEE MY DIAGRAM AND VISUALIZE AND MEASURE FROM UR TANK TOP !!!
Have fun measuring guys , really not that difficult !!!