View Single Post
Old 09-09-2014, 07:48 PM   #262
Vitor
Dragon
 
Join Date: Jun 2013
Posts: 1,079
Default

I did for my 522. using 4ft PP boards at bras bersah art friend, cheap and good.

1 whole pic is not able to cover fully and wont go in because of bracing at centre.

so i bought and cut the PP boards to slightly less 2 ft to fit into the height of the tank. total i bought 3 pcs all cut to 2ft less a bit for height(or above the water level)

measure the width , slightly less than 2 ft.
i will cut the outer layer only so to easy to bent on the inner layer.
bent already will be 2 ft less so u can insert into tank.

then put both left and right side. so will be a gap at centre.
then the centre cut the 3rd pp board to 4" longer than gap measured.
then fill the gap at the centre with 2" each side overlapping.

i use suction cups to hold. every corner.
8 cups on both sides. the center pc is held by the 2 side boards pressed.

so far no issue for the 7mths i used. and later thrown away.
better and not shiny so no reflection.
Vitor is offline   Reply With Quote