CO2 Diffuser does not bubble evenly
Hi,
I just recently bought a CO2 diffuser. I just saw that the bubble is coming out from 5 tiny holes on one side of the large white surface. Is there any way to make the bubble coming out from the round surface evenly? Thanks! |
I think it is quite common for it not to be so evenly distributed. If the pressure is not so strong then it will just come out from a few areas.
I only get a wider distribution when I have higher bps so the pressure will force it to come out from more pores. |
I will try to increase the CO2 to utilize the diffuser area then decrease the CO2 again.
|
All times are GMT +9. The time now is 02:22 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Copyright © 2000-2008 Arofanatics.com (Since 30th August 2000)